Types of Laser Marking

Types of laser marking generally fall into one of three categories: Ablation, Engraving and Stain marking.

laser marking, fiber laser markingAblation marking involves removing a film or layer of material on the part. The stark white marking achieved on anodized aluminum is an example of ablation marking. The anodize is ablated away and a white oxide layer is formed on the surface of the part resulting in a white mark. Ablation marking is not particularly sensitive to laser spot size.

 

 

deep laser engraving electrical

Engraving is just as the name implies. The focused laser beam will vaporize material from the surface of the part resulting in marking depths as deep as .1 inches. Deep engraving almost always requires multiple laser passes and each pass removes a thin layer of material. Generally speaking, smaller spot sizes yield better results when an engraving technique is used. (Click image to enlarge.)

 

laser marking, fiber laser marking

Stain marking is one of the most useful marking techniques for fiber lasers, but it is also one of the most misunderstood techniques.

Stain marking can provide a permanent, dark mark on stainless steel, titanium and hard chrome. The stain mark is accomplished by using a relatively large focused spot size in order to heat the surface of the part sufficiently such that an oxide layer is formed on its surface but the laser beam will not vaporize material from the surface. The technique most commonly used to increase the size of the focused laser spot size is to simply move the lens away from the work piece so that it is no longer in focus.

This is a poor technique for the following reasons:

1. Marking at a distance other than the focal point of the lens can be subjective and hard to repeat.

2. When the lens on a steered beam marker is moved away from the focal point, the field size calibration is no longer correct and marking will not be to size.

3. When marking on a curved surface, the focused spot size will change as the laser beam is moved over the curvature of the part.

How far one can mark around that curvature is mainly determined by the “depth of focus” of the optical system. If the lens is already been placed out of focus in order to achieve the correct spot size for a stain mark then there is no depth of focus available. Marking around a curved surface with an out of focus laser beam makes stain marking difficult, if not impossible. (For more information on focused laser beams check out this article if you are interested). The diagram below illustrates how the laser beam acts at the focal point and on either side of the focal point. There is no depth of focus with an out of focus lens.

Laser Marking Beam Width resized 600

Please contact Jimani if we can help you with you laser marking.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Contact Us